Managing a pair

Below the table sits a danger zone with two destructive actions. Both are per-symbol and cannot be undone — read the caveat before using them.

📷 Screenshot: the danger-zone buttons (Check and Cancel all / Delete current series).

Check and Cancel all <pair>

Queries the exchange for every open order on this symbol and cancels them.

Use it to flatten a pair — pull all resting orders in one click, for example before reconfiguring or when you want the bot out of the book.

Acts on the whole symbol

This cancels all open orders for the pair on your account — the bot's grid and any manual orders you placed yourself. The exchange does not distinguish them, so this is by design. If you have unrelated orders on the same symbol, they go too.

Do not trade one symbol in both directions at once

Avoid running the same pair in Long and Short simultaneously on one account (for example BTCUSDC Long and BTCUSDC Short). Destructive actions operate on the whole symbol, not on a logical direction, so a cancel action may pull orders from both sides.

Delete current series

Removes the saved cycle for this pair — the stored grid and its state.

It is disabled unless there is a current series to delete. Deleting throws away the bot's record of the open cycle for that pair; it does not, by itself, sell a position. Cancel the live orders first (above), then delete the series to start clean.

DANGER

Deleting the series discards the bot's bookkeeping for the cycle (fills, banked profit, position size). Do this only when you intend to abandon that cycle — never as a way to "refresh" a running one.

Order of operations to reset a pair

1. Stop the cycle (the Start/Stop button).
2. Check and Cancel all — pull every resting order for the symbol.
3. Delete current series — clear the stored cycle.
4. Reconfigure, Calculate, Save, Start again.